Supports Dual Channel 200/266/333 & up ( *DDR 400)
HT (Hyper-Threading) Support
Supports Socket 478 for Intel Pentium 4 / Celeron processors
Supports up to 3.06GHz and higher speed of CPU with FSB 400/533 (HT Support)
SiS® 655 Chipset (B-Stepping)
- Supports Dual channel DDR 333/DDR 266 memory controller
- Supports AGP 8X or 4X at 0.8v (AGP 3.0) or 4X at 1.5v (not support 4x at 3.3v)
- Supports bi-directional 16-bit data bus with 1GHz bandwidth MuTIOL
SiS® 963 Chipset
- Supports Dual-IDE ATA 66/100/133
- Integrated audio controller with AC97 interface
- Low pin count interface for SIO
- Advanced power management and PC2001 compliance
Note: 655 Max can supports HT CPU with SiS 655 B0 chipset. You can identify the version by "HT Ready" sticker on SouthBridge chipset and packaging box.
400/533 MHz FSB
Supports four unbuffered non-ECC 2.5 Volt of DDR SDRAM.
Supports up to 4GB memory size.
Supports Dual channel DDR 200/DDR 266/DDR 333 MHz and up.
One AGP slot that support AGP 8X or 4X at 0.8v (AGP 3.0) or 4X at 1.5v (not support 4x at 3.3v)
Six PCI 2.2 32-bit Master Bus slots. (support 3.3v/5v)
The mainboard BIOS provides "Plug & Play" BIOS which detects the peripheral devices and expansion cards of the board automatically.
2Mb AMI BIOS w/ PnP, ACPI, SMBIOS 2.3, Green and Boot Block.
- Provides DMI2.0, WfM2.0, WOL, WOR, chassis intrusion, and SMBus for system management.
Dual IDE controllers integrated in SiS 963.
Support PIO, Bus Master, Ultra DMA66/100/133 operation.
Can connect up to four IDE devices.
AC97 link controller integrated in SiS 963.
6 channels software audio codec C-Media 9739A.
- Compliance with AC97 v2.2 Spec.
- Meet PC2001 audio performance requirement.
- Can support SPDIF Out via S-Bracket only.
- Integrated Gigabit Ethernet MAC and PHY transceiver, auto-negotiation operation.
- Supports single-port 10MB/s, 100MB/s and 1000MB/s BAST-T application.
- Compliance with PCI v2.2, mini PCI 1.0 and LAN on Motherboard (LOM) standard.
Serial ATA interface
Support 2 serial ATA plus / ATA133
- RAID O or 1 are supported
- RAID function works w/ATA133+SATA H/D or 2 SATA H/D
Connect up to 2 Serial ATA devices and 1 ATA133 device.
- 1 floppy port supports 2 FDDs with 360K, 720K, 1.2M, 1.44M and 2.88Mbytes.
- 2 serial ports (COM A + COM B)
- 1 parallel port supports SPP/EPP/ECP mode.
- 6 USB 2.0 ports (Rear * 4 / Front * 2)
- 1 Line-In/Line-Out/Mic-In port
- 2 PS/2 connectors
- 1 RJ-45 LAN connector
30.5 cm(L) x 23.5 cm(W) ATX Form Factor
6 mounting holes.